Cet article n'est pas disponible en French. Affichez-la en English
It’s entirely feasible that the effect has been configured to Stereo mode, which could result in unexpected behavior when using a standard ¼” audio cable for output. Resolving this is simple; just remove the screws holding the rubber feet and bottom panel of the pedal, and check the small switch found near the battery compartment. The board is labeled with Mono and Stereo markings, so make sure your switch is set to Mono unless you are utilizing a stereo ¼” cable.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article